Back to Põhiplaadid

Iteaduino

18.50

Iteaduino is an Arduino compatible board. It’s designed is basing on Arduino UNO/Duemilanove, 100% compatible to its existing program and shields, and with much practical improvement. It’s about 50% power consumption of the original Arduino boards. Support both 3.3v and 5v operation level.

Iteaduino is an Arduino compatible board. It’s designed based on Arduino Duemilanove/UNO, 100% compatible to its existing program,shield,  and with much practical improvement. It’s about 50% power consumption of the original Arduino boards. Support both 3.3v and 5v operation level.

Laost otsas

Kategooriad: ,

Kirjeldus

Iteaduino is an Arduino compatible board. It’s designed based on Arduino Duemilanove/UNO, 100% compatible to its existing program,shield,  and with much practical improvement. It’s about 50% power consumption of the original Arduino boards. Support both 3.3v and 5v operation level.

Basic features

  • Inherits all of Arduino Duemilanove features.
  • Compatible with Arduino UNO/Duemilanove pins, holes and dimensions.
  • 3.3V/5V Operating Voltage selection
  • More visible location of Indicator LEDs
  • Wide range external power supply from 7~23V DC
  • All pins out for Sensor and Servo
  • UART/IIC interface breakout

 

What are the changes from Arduino to Iteaduino

  1. Wider power supply range to 23V, and higher conversion efficiency
  2. 3.3V Operating Voltage selection to easier connect with 3.3V device
  3. Easier access to reset button
  4. More visible location for LEDs for Power , RX and TX.
  5. Sensor and Servo/Digital interface break out
  6. Re-route PCB for analog/digital part
  7. Mini USB socket for fixing more shield

 

Hardware

Digital Interface: D0~D13 pin

Analog Interface: A0 A1 A2 A3 A4 A5 pin

Because of the DC-DC power supply design, it will povide higher conversion effciency than the LDO chip on original Arduino boards, it will save 50% power consumption, especially in the high-current power supply.

Iteaduino has all pins broken out, so it can connect wiht the servo and Electronic/ Sensor Brick by the 3PIN cable directly, you don’t need the shields as an adaptor.

Iteaduino can work in both 5V and 3.3V by the operation level switch, so you can use Iteaduino to connect with 3.3V level device directly , which the original Arduino boards can not.

Both IIC and UART pins breakout, easier for prototype connection.

 

Specification

Microcontroller ATMega328P
Max Frequency 16MHz
RAM Capacity 2K
FLASH Capacity 32K
External Resources Electronic Brick Interface
Power Supply
  • External 24V
  • External 7V
  • External 9V
  • External 12V
  • USB 5V
I/O Operation Level
  • 3.3V
  • 5V
Board Size 69mm x 57mm
Model IM120411008
Version 2.2
Weight 45.00g
Accessories N/A

 

 

Documents

Datasheet (Atmega328)
Datasheet (Iteaduino)
Schematic

Lisainfo

Kaal 45 g
Mõõtmed 69 × 57 mm

Arvustused

Tooteülevaateid veel ei ole.

Ole esimene, kes hindab toodet “Iteaduino”

Sinu e-postiaadressi ei avaldata. Nõutavad väljad on tähistatud *-ga

This site uses Akismet to reduce spam. Learn how your comment data is processed.