Kirjeldus
Iteaduino-BT is an Arduino compatible board with a master/slave Bluetooth Module HC-05. It based on Arduino UNO/Duemilanove, 100% compatible to its existing program and shields, but with the bluetooth wireless funcion. It’s about 50% power consumption of the original Arduino boards.
Basic features
- Design for Bluetooth communication
- Compatible with Arduino UNO/Duemilanove pins, holes and dimensions
- Wide range external input from 7~23V DC
- Pins out for Sensor and Servo
- 3.3V/5V Operating Voltage selection
Hardware
Digital/Servo Interface: D0~D13 pin
Sensor Interface: A0 A1 A2 A3 A4 A5 pin
HC-05 operate mode set switch
There is a 1P2T switch for HC-05 operation mode set. When the switch is set on “DAT” side, the HC-05 will work in the data mode. When the switch is set on “CMD” side, the HC-05 will work in command mode, in this mode, Iteaduino/FT232R could send the AT command to centigrade the HC-05 module (Using Baud Rate 38400). To change the mode, you need to reset the iteaduino BT after you put the switch.
Communicate mode set jumper
There is a jumper to set the connections of HC-05. When the jumpers are set in B side, the HC-05 communicates with FT232R to USB/PC, when the jumpers are set to A, the HC-05 communicates with Atmega328P(onboard).
Specifacation
Microcontroller | ATMega328P |
---|---|
Max Frequency | 16MHz |
RAM Capacity | 2K |
FLASH Capacity | 32K |
External Resources |
|
Power Supply |
|
I/O Operation Level |
|
Board Size | 75mm x 57mm |
Model | IM120411006 |
Version | 1.1 |
Weight | 45.00g |
Accessories | N/A |
Documents
Datasheet (ATMEGA328)
Datasheet (Iteaduino BT)
Demo Code
Schematic
Arvustused
Tooteülevaateid veel ei ole.